Forum Navigation
Post History: GPSWebShop Official
The V-1000 comes equipped with a BOSCH barometric sensor, widely recognized as the highest-performin …In: How to Configure Columbus V-1000 to Log Altitude Data with Vertical Accuracy Up to 1 Meter?
2 years ago
By design, the usb port of V-900 / V-990 is NOT for transferring log data. (The usb port is used for …In: Why Columbus V-900 / V-990 GPS can not transfer log data via USB port?
2 years ago
If the memory card does not meet the following 2 requirements, you will hear continuous short beep f …In: What are the Columbus V-900 / V-990 GPS memory requirements.
2 years ago
Check out this table on the manufacturer's official website for more information.
https://cbgp …In: Side by side comparison for Columbus V-800, V-900, V-990, V1000, P-1 Mark II, P-7 Pro and P-10 Pro?
2 years ago
In the display window of Google Earth, you should drag away the time bar. Please move away the time …In: Why can I only see the track line but no track points after exporting a track on the V-900/V-990 GPS data logger?
2 years ago
You should install the latest version of “Google Earth”, which may be downloaded from: http://earth. …In: Why is nothing happening when I click a voice point on V-900/V-990 GPS?
2 years ago
Check out this article on the manufacturer's blog for more information.
https://cbgps.com/down …In: How to use a largeMicroSD memory card(>4GB) for V-990/V900?
2 years ago
You must click the “Fly Mode” before exporting a track logged on a plane (you should restart the “Ti …In: How to show the track points logged in the Fly Mode?
2 years ago
According to the default setting of “Settings” – “Advanced” in your “Time Album”, 2D tracks are expo …In: How to export 3D tracks?
2 years ago
After installing the driver, the default V-800 MarkIII factory settings are :Multi-GNSS: GPS, GLONAS …In: How to change Baud Rate, Output Sentences and Refresh Rate of V-800 Mark III GNSS?
2 years ago
2 years ago
P-1 – CEP(50%) 2.5 metersP-1 Mark II – CEP(50%) 1.5 metersP-10 Pro – CEP(50%) 0.5 metersIn: Can you compare the accuracy between these 3 Columbus data loggers - P-1, P-1 Mark II and P-10 Pro?
2 years ago
No, the main unit of P-7 Pro can not work alone. It must connect to the antenna (which comes with th …In: Can the main unit of the P-7 Pro work without connecting the antenna?
2 years ago
If connected by USB port, the baud rate of P-7 Pro must be set to 57,600. If you connect using anoth …In: Why is there no data output sometimes when I connect the P-7 Pro by USB port?
2 years ago
The P-7 Pro location data output represents the location of the antenna.In: Does the location data output from P-7 pro represent the location of the antenna or the main unit?
2 years ago
There are a few reasons why this might be the case. First of all, there aren't many SBAS satell …In: Are you having trouble seeing SBAS satellites even though you've enabled them in your P-7 Pro?
2 years ago
The P-9 Race's main unit cannot operate without being connected to an external antenna, An exte …In: Is it possible for the main unit of the P-9 Race to function without being connected to the antenna?
2 years ago
As a standard USB to serial port device, the P-9 Race is compatible with any commonly used baud rate …In: What is the baud rate for output from the P-9 Race?
2 years ago
The P-9 Race location data output refers to the location of the antenna.In: When the P-9 Race outputs location data, is it referring to the position of the antenna or the main unit?
2 years ago
Check out this article on the manufacturer's blog for more information.
https://cbgps.com/p9/a …In: How to view the positioning information output by P-9 Race?
2 years ago
Check out this article on the manufacturer's blog for more information.
https://cbgps.com/p1m2 …In: Troubleshooting Unexpected Shutdowns on the P-10 Pro: Symptoms, and Solutions.
2 years ago
Check out this article on the manufacturer's blog for more information.
https://cbgps.com/p10/ …In: How to Record Tracks Using a MicroSD Card (64G and Above) on P-10 Pro?
2 years ago
Many apps in the market calculate accuracy based on a single frequency satellite system, where the a …In: Why is the P-7 Pro experiencing reduced accuracy when tested with certain apps?
2 years ago
Many apps in the market calculate accuracy based on a single frequency satellite system, where the a …In: Why is the P-10 Pro experiencing reduced accuracy when tested with certain apps?
2 years ago
The occurrence of "5 short beeps" indicates a file format error. This usually happens when …In: Why am I hearing 5 short beeps instead of 1 long beep when configuring the P-10 Pro?
2 years ago
Please Check out the manufacturer's blog post below for more information.
https://cbgps.com/do …In: How to get a high accuracy GPS track?
2 years ago
The below table side by side compares the 2 high accuracy GNSS positioning technologies. RTK and Col …In: Comparing High Accuracy GNSS Positioning Technologies: RTK vs. Dual-Frequency
2 years ago
For firmware update instructions, please visit http://cbgps.com/p10/firmware/index_en.html.
Here ar …In: Columbus P-10 Pro firmware update and factory reset instructions
2 years ago
In the situation of :
If you try to downgrade the P-10 pr firmware to a previous version, it will f …In: How to fix the "freeze" issue when updating the firmware of Columbus P-10 Pro?
2 years ago